Chicken Fried Steak

Ingredients

  • 6 cubed steaks (about 2 pounds)
  • salt and freshly ground black pepper, to taste
  • ½ cup all purpose flour
  • 2 large eggs
  • ⅓ cup milk
  • 25 saltine crackers, crushed
  • ½ cup all purpose flour
  • 1 teaspoon seasoned salt
  • 1 teaspoon garlic powder
  • ¼ teaspoon cayenne pepper or paprika
  • lard (I prefer lard but you could use vegetable shortening or oil)

For the sawmill (white) gravy:

  • ¼ cup all-purpose flour
  • 1 ½ to 2 cups whole milk
  • salt and pepper, to taste

Instructions

  • If your 6 cubed steaks are more than 1/2” thick, you’ll want to pound it out with a meat mallet until thin. This will provide additional tenderizing as well as allowing for more even cooking. Season cubed steaks lightly with salt and freshly ground black pepper, to taste.
  • On a plate or shallow bowl add 1/2 cup all purpose flour, set aside. In a second shallow bowl, whisk together 2 large eggs and 1/3 cup milk
  • In a third shallow bowl, mix 25 saltine crackers, crushed1/2 cup all purpose flour1 teaspoon seasoned salt1 teaspoon garlic powder and 1/4 teaspoon cayenne pepper or paprika (if using.)
  • Dredge cubed steak in flour, then dip in egg mixture and then finally coat with saltine cracker mixture.
  • Continue the same procedure for the rest of the steaks and place them on a large baking sheet.
  • Heat about 1/2-inch lard in a large pan (preferably cast iron) over medium heat. Note: I prefer shortening or lard for these but use the oil you prefer. Cook steak in 2 batches for about 5 minutes per side. Continue with the rest of the steaks.
  • Remove steaks to a paper towel-lined baking sheet to drain excess oil.

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *